Part 21 Report - 1998-153

ACCESSION #: 9803030035 LICENSEE EVENT REPORT (LER) FACILITY NAME: Virgil C. Summer Nuclear Station PAGE: 1 OF 4 DOCKET NUMBER: 05000395 TITLE: 10 CFR Part 21 Report on failed electrical governor (EG- A) on the "A" Emergency Diesel Generator EVENT DATE: 01/09/98 LER #: 98-002-0 REPORT DATE: 02/26/98 OTHER FACILITIES INVOLVED: DOCKET NO: 05000 OPERATING MODE: 1 POWER LEVEL: 100 THIS REPORT IS SUBMITTED PURSUANT TO THE REQUIREMENTS OF 10 CFR SECTION: OTHER LICENSEE CONTACT FOR THIS LER: NAME: A.R. Rice, Manager, Nuclear Licensing TELEPHONE: (803) 345-4232 & Operating Experience COMPONENT FAILURE DESCRIPTION: CAUSE: X SYSTEM: EK COMPONENT: DG MANUFACTURER: C470 REPORTABLE NPRDS: Y SUPPLEMENTAL REPORT EXPECTED: NO ABSTRACT: This notification is made pursuant to 10 CFR Part 21. On January 9, 1998, Condition Evaluation Report (CER) 98-0038 and Non-Conformance Notice (NCN) 98-0038 reported the failure of EG-A control, serial number 1425251. Due to potential applications in the industry and the safety significance of its application as a governor control for Emergency Diesel Generators (EDGs), this failure is considered to be reportable under 10 CFR Part 21. In this case, V. C. Summer Nuclear Station ensured that adequate on site testing had been performed to the associated EG-A to verify its operable status. The vendor, Engine Systems, Incorporated (ESI), has been notified of this situation and understands that a Part 21 notification is being submitted based on their certification of the EG-A (with inadequate post-refurbishment bench testing by the vendor), that did not identify intermittent failures in electrical components (such as potentiometers and zener diodes). A team from VCSNS procurement engineering visited the vendor's repair facility (Woodward Governor Company) in Fort Collins, CO, to evaluate their repair program. Future purchase requisitions for EG-A repair/refurbishment will include requirements for an extended burn-in period and bench testing of the EG-A control for detection of intermittent failures. END OF ABSTRACT TEXT PAGE 2 OF 4 This notification is made pursuant to 10 CFR Part 21. PLANT IDENTIFICATION: Westinghouse - Pressurized Water Reactor EQUIPMENT IDENTIFICATION: "A" Train Emergency Diesel Generator (XEG0001A) - EIIS - EA The defective governor component is a Woodward model EGA electrical governor. IDENTIFICATION OF EVENT: On January 9, 1998, Condition Evaluation Report (CER) 98-0038 and Non-Conformance Notice (NCN) 98-0038 reported the failure of EG-A control, serial number 1425251. Due to potential applications in the industry and the safety significance of its application as a governor control for Emergency Diesel Generators (EDGs), this failure is considered to be reportable under 10 CFR Part 21. In this case, V. C. Summer Nuclear Station ensured that adequate testing had been performed on site to the associated EG-A to verify its operable status. The vendor, Engine Systems, Incorporated (ESI), has been notified of this situation and understands that a Part 21 notification is being submitted based on their certification of the EG-A (with inadequate post- refurbishment bench testing by the vendor), that did not identify intermittent failures in electrical components (such as potentiometers and zener diodes). A team from VCSNS procurement engineering visited the vendor's repair facility (Woodward Governor Company) in Fort Collins, CO, to evaluate their repair program. EVENT DATE: January 9, 1998 REPORT DATE: February 26, 1998 This Licensee Event Report (LER) was initiated by Condition Evaluation Report (CER) 98-0038. CONDITIONS PRIOR TO EVENT: Model 1 - Reactor Power 100%. TEXT PAGE 3 OF 4 DESCRIPTION OF EVENT: On January 9, 1998, Condition Evaluation Report (CER) 98-0038 and Non-Conformance Notice (NCN) 98-0038 reported the failure of EG-A control, serial number 1425251. Due to potential applications in the industry and the safety significance of its application as a governor control for Emergency Diesel Generators (EDGs), this failure is considered to be reportable under 10 CFR Part 21. In this case, V. C. Summer Nuclear Station ensured that adequate testing had been performed on site to the associated EG-A to verify its operable status. The vendor, Engine Systems, Incorporated (ESI), has been notified of this situation and understands that a Part 21 notification is being submitted based on their certification of the EG-A (with inadequate post-refurbishment bench testing by the vendor), that did not identify intermittent failures in electrical components (such as zener diodes). VCSNS sent EG-A serial number 1425251 to the vendor for repair, due to intermittent spiking problems. Following vendor refurbishment and testing, VCSNS tests showed that the problem still existed. The EG-A unit was sent back to the vendor, where they again performed their required tests with satisfactory results. They next duplicated our test by monitoring the device output over a period of time to look for intermittent output problems. At this point, the vendor observed the problem and replaced two additional components. Intermittent failures of this type can result in operation of components outside of their design basis requirements. The diesel's design basis function is to carry its associated 7.2kV bus, without being paralleled to the off-site grid. In this configuration, EG-A control output spiking results in diesel speed (frequency) changes. Adverse affects resulting from spurious speed changes can include: 1. The ready for load permissive will not allow diesel breaker closure if the frequency is below 58.8 hertz. (Ref. DG DBD section 3.9.4) 2. Plant ESF motors are not required by design, to accelerate equipment to rated speed if the frequency is more than 5% below rated (i.e. 57 hertz). (Ref. FSAR section 8.3.1.1.4.2) 3. When ESF sequencer load blocks are loaded on the diesel, frequency is required to remain above 55.5 hertz. (Ref. FSAR section 8.3.1.1.2.4) 4. When ESF sequencer load blocks are loaded on the diesel, frequency is required to return to within 2% of 60 hertz within 2 seconds. (Ref. FSAR section 8.3.1.1.2.4) 5. Motor speeds vary in direct proportion to engine frequency; and systems with centrifugal pumps experience flow changes in direct proportion to speed changes. Therefore, frequency dips could decrease system flows below their design requirements. 6. The diesel generator, step-down transformers, and motors could exceed their design volts/hertz limits. As frequency drops, the voltage regulator tends to maintain voltage, so the volts per hertz ratio increases. If this ratio gets above the flux saturation limit for the iron in the device, excessive heating and premature failure can occur. The EG-A spikes and erratic changes varied in magnitude and duration. Therefore, it is very hard to put a bound on the lower limit of possible frequency dips. Increases in frequency would be bounded by the mechanical governor speed setting. This programmatic repair/testing deficiency creates the potential for common mode failures and operation outside of the plant design basis. Therefore, based on the above affects, a substantial safety hazard could be introduced. A team from VCSNS procurement engineering visited the vendor's repair facility (Woodward Governor Company) in Fort Collins, CO, to evaluate their repair program. It was determined that inadequate post-refurbishment bench testing by the vendor was being conducted. Future purchase requisitions for EG-A repair/refurbishment will include requirements for an extended burn-in period and bench testing of the EG-A control for detection of intermittent failures. TEXT PAGE 4 OF 4 CAUSE OF EVENT: The cause of the "A" EDG frequency oscillations was inadequate post-refurbishment bench testing by the vendor, that did not identify intermittent failures in electrical components (such as potentiometers and zener diodes). Follow-up testing by the governor manufacturer showed the EG-A unit was unstable. Additional vendor evaluation is ongoing to include possible enhancements to their test program. Future SCE&G purchase requisitions for diesel generator EG-A repair/refurbishment will include requirements for an extended burn-in period and bench testing of the EG-A control for detection of intermittent failures. ANALYSIS OF EVENT: A team from VCSNS procurement engineering visited the vendor's repair facility (Woodward Governor Company) in Fort Collins, CO, to evaluate their repair program. The cause of the 'A' EDG frequency oscillations was inadequate post-refurbishment bench testing by the vendor, that did not identify intermittent failures in electrical components (such as potentiometers and zener diodes). Future SCE&G purchase requisitions for EG-A repair/refurbishment will include requirements for an extended burn-in period and bench testing of the EG-A control for detection of intermittent failures. There are no adverse consequences for the event. The defective EG-A was discovered by on site bench testing which was confirmed at the vendor's facility. The replacement EG-A was satisfactorily tested prior to installation on "A" EDG. IMMEDIATE CORRECTIVE ACTIONS: o The vendor, Engine Systems, Incorporated (ESI), was notified of this situation and understands that a Part 21 notification has been made. o Vendor satisfactorily repaired and tested the associated EG-A. ADDITIONAL CORRECTIVE ACTIONS: o Future purchase requisitions for EG-A repair/refurbishment will include requirements for an extended burn-in period and bench testing of the EG-A control for detection of intermittent failures. o SCE&G is continuing to monitor vendor evaluation of this event. Any additional recommended corrective actions by the vendor will be reviewed for applicability to the V. C. Summer Nuclear Station. PRIOR OCCURRENCES: None. ATTACHMENT TO 9803030035 PAGE 1 OF 1 South Carolina Electric & Gary J.Taylor Gas Company P.O. Box 88 Vice President Jenkinsville, SC 29065 Nuclear Operations (803) 345-4344 SCE&G February 26, 1998 RC-98-0036 Document Control Desk U. S. Nuclear Regulatory Commission Washington, DC 20555 Gentlemen: Subject: VIRGIL C. SUMMER NUCLEAR STATION DOCKET NO. 50/395 OPERATING LICENSE NO. NPF-12 LICENSEE EVENT REPORT (LER 98-002) Attached is Licensee Event Report (LER) No. 98-002 for the Virgil C. Summer Nuclear Station. This report is submitted pursuant to the requirements of 10 CFR 21.21(a)(1). Should you have any questions, please call Mr. Michael J. Zaccone at (803) 345-4328. Very truly yours, GJT/mjz Gary J. Taylor Attachment c: J. L. Skolds D. L. Abstance W. F. Conway R. J. Waselus R. R. Mahan (w/o attachment R. L. Osborne R. J. White R. E. Slone L. A. Reyes G. A. Robertson L. M. Padovan J. B. Knotts Jr. R. B. Clary NRC Resident Inspector S. F. Fipps INPO Records Center A. R. Koon Marsh & McLennan G. E. Williams NSRC T. L. Matlosz RTS (LER 980002, SSH 980001) B. C. Williams Files (818.07, 818.18) P. Ledbetter DMS RC-98-0036 NUCLEAR EXCELLENCE - A SUMMER TRADITION! *** END OF DOCUMENT ***

Page Last Reviewed/Updated Tuesday, March 09, 2021